The Extension Harness - Long is a 8 pin Molex (male) to 8 Pin Molex (female) entension harness 1100mm long that allows you to extend the length of all Woolich Racing Harnesses. You must have a Race Tool Package to use the Pit Speed Limiter Harness. The Pit Speed Limiter harness is used with our Race Tools Package, it consists of a harness and water proof push button switch which allows you to limit the RPM of the bike in 1st gear while riding in the pits. The Launch Control Key allows you to enable the Launch Control for one ECU. If you already have a Quickshifter or Air Shifter installed on your bike or you only need the Launch Control function you can purchase this Launch Control Key. It allows you to set a Launch RPM and also Ramp Parameters to assist with getting fast consistent launches from your bike, all controlled by the stock ECU. Launch Control is part of the our Race Tools Package.
Zx10r ecu flash install#
If you do not have a Woolich Racing Interface you can also visit a Woolich Racing - Tuning Partner and have them install and configure the Race Tools (additional fees and charges will apply). You can purchase this as a package on the product page for your bike. You will need to use the relevant Woolich Racing Interface and Bin File Definition to enable and configure Race Tools and write to the ECU.
Woolich Racing Race Tools requires you to Write the ECU. *** Pit Speed Limiter harness sold separately. Should be removed from the bike and disabled in our software Swap the shift rod for a generic rod that can be cut and tapped toĮxhaust Valve plugs on the bike's harness, the stock Exhaust Valve RPM to limit the speed while riding through the pits.***Īfter-market rearsets or are using a race shift pattern and we will
Launch Control allows you to configure Delay, Launch RPM, Ramp Time and Ramp RPM The quickshifter kills both fuel and ignition.
Zx10r ecu flash full#
Race Tools on one ECU in the Woolich Racing Tuned software.Ĭonfigurable per gear with 3D maps allowing Kill Times to be set for the full range of TPS and RPM combinations. Quickshifter to be plugged into the bikes wiring harness**